Aí vai:
sudo lshw -C network
$ sudo lshw -C network
[sudo] password for proton:
*-network
descrição: Ethernet interface
produto: RTL8111/8168B PCI Express Gigabit Ethernet controller
fabricante: Realtek Semiconductor Co., Ltd.
physical id: 0
informações do barramento: pci@0000:02:00.0
nome lógico: eth0
versão: 02
serial: 00:1f:d0:e5:82:82
tamanho: 10Mbit/s
capacidade: 1Gbit/s
largura: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress msix vpd bus_master cap_list rom ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiation
configuração: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=half firmware=N/A latency=0 link=no multicast=yes port=MII speed=10Mbit/s
recursos: irq:41 ioport:de00(tamanho=256) memória:fdaff000-fdafffff memória:fdae0000-fdaeffff memória:fda00000-fda0ffff
*-network
descrição: Interface sem fio
physical id: 1
informações do barramento: usb@1:3
nome lógico: wlan0
serial: c8:60:00:5e:35:a4
capabilities: ethernet physical wireless
configuração: broadcast=yes driver=r8712u multicast=yes wireless=unassociated
iwconfig
$ iwconfig
lo no wireless extensions.
wlan0 unassociated Nickname:"rtl_wifi"
Mode:Managed Access Point: Not-Associated Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
eth0 no wireless extensions
ifconfig -a
$ ifconfig -a
eth0 Link encap:Ethernet Endereço de HW 00:1f:d0:e5:82:82
UP BROADCAST MULTICAST MTU:1500 Métrica:1
pacotes RX:0 erros:0 descartados:0 excesso:0 quadro:0
Pacotes TX:0 erros:0 descartados:0 excesso:0 portadora:0
colisões:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
IRQ:41 Endereço de E/S:0xa000
lo Link encap:Loopback Local
inet end.: 127.0.0.1 Masc:255.0.0.0
endereço inet6: ::1/128 Escopo:Máquina
UP LOOPBACK RUNNING MTU:16436 Métrica:1
pacotes RX:56 erros:0 descartados:0 excesso:0 quadro:0
Pacotes TX:56 erros:0 descartados:0 excesso:0 portadora:0
colisões:0 txqueuelen:0
RX bytes:3344 (3.3 KB) TX bytes:3344 (3.3 KB)
wlan0 Link encap:Ethernet Endereço de HW c8:60:00:5e:35:a4
UP BROADCAST MULTICAST MTU:1500 Métrica:1
pacotes RX:0 erros:0 descartados:0 excesso:0 quadro:0
Pacotes TX:0 erros:0 descartados:0 excesso:0 portadora:0
colisões:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
nm-tool
$ nm-tool
NetworkManager Tool
State: disconnected
- Device: wlan0 ----------------------------------------------------------------
Type: 802.11 WiFi
Driver: r8712u
State: disconnected
Default: no
HW Address: C8:60:00:5E:35:A4
Capabilities:
Wireless Properties
WEP Encryption: yes
WPA Encryption: yes
WPA2 Encryption: yes
Wireless Access Points
ARRUDA: Infra, B0:48:7A:B4:07:C6, Freq 2452 MHz, Rate 54 Mb/s, Strength 100 WPA
UNICEL: Infra, 00:15:6D:A6:B8:A2, Freq 2412 MHz, Rate 54 Mb/s, Strength 62 WPA2
- Device: eth0 -----------------------------------------------------------------
Type: Wired
Driver: r8169
State: unavailable
Default: no
HW Address: 00:1F:D0:E5:82:82
Capabilities:
Carrier Detect: yes
Wired Properties
Carrier: off
rfkill list wifi
Não houve nenhuma saída de texto, o terminal simplesmente executou o comando.