Olá, estou precisando de uma ajuda.
Estou com mais de 50 CD-ROMs que recebi da TIM (telecomunicações/ celular) com gravações de ligações ao serviço de atendimento ao consumidor.
Como não preciso mais delas, pensei em dar melhor uso para essas mídias.
Mas ao tentar apagar o CD com esses comandos:
$umount /dev/cdrom
$wodim -vv dev=/dev/cdrom blank=all
Aparece o seguinte resultado:
fabio@fabio-ldesktop:~$ umount /dev/cdrom
fabio@fabio-ldesktop:~$ wodim -vv dev=/dev/cdrom blank=all
TOC Type: 1 = CD-ROM
wodim: Operation not permitted. Warning: Cannot raise RLIMIT_MEMLOCK limits.
scsidev: '/dev/cdrom'
devname: '/dev/cdrom'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Wodim version: 1.1.10
Using libusal version 'Cdrkit-1.1.10'.
SCSI buffer size: 64512
Device type : Removable CD-ROM
Version : 5
Response Format: 2
Capabilities :
Vendor_info : 'HL-DT-ST'
Identification : 'DVD-RAM GSA-H22N'
Revision : '1.02'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0009 (CD-R)
Profile: 0x0012 (DVD-RAM)
Profile: 0x002B (DVD+R/DL)
Profile: 0x001B (DVD+R)
Profile: 0x001A (DVD+RW)
Profile: 0x0016 (DVD-R/DL layer jump recording)
Profile: 0x0015 (DVD-R/DL sequential recording)
Profile: 0x0014 (DVD-RW sequential recording)
Profile: 0x0013 (DVD-RW restricted overwrite)
Profile: 0x0011 (DVD-R sequential recording)
Profile: 0x0010 (DVD-ROM)
Profile: 0x000A (CD-RW)
Profile: 0x0009 (CD-R) (current)
Profile: 0x0008 (CD-ROM)
Profile: 0x0002 (Removable disk)
Drive current speed: 48
Drive default speed: 48
Drive max speed : 48
Selected speed : 48
Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1114112 = 1088 KB
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
Drive DMA Speed: 107520 kB/s 610x CD 77x DVD
01 00 00 01 00 00 00 00
01 a 01 01 00 00 00 00
Track 1 start -150
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 5
Is not unrestricted
Is not erasable
Disk sub type: Medium Type B, low Beta category (B-) (4)
ATIP start of lead in: -11607 (97:27/18)
ATIP start of lead out: 359849 (79:59/74)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 18
Manufacturer: Plasmon Data systems Ltd.
Speed set to 8468 KB/s
Starting to write CD/DVD at speed 48.0 in real BLANK mode for single session.
Last chance to quit, starting real write in 0 seconds. Operation starts.
Performing OPC...
Blanking entire disk
Errno: 5 (Input/output error), blank unit scsi sendcmd: no error
CDB: A1 00 00 00 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0E 00 00 00 00 64 00 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x64 Qual 0x00 (illegal mode for this track) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.001s timeout 9600s
wodim: Cannot blank disk, aborting.
fabio@fabio-ldesktop:~$ wodim -vv dev=/dev/cdrom blank=all
TOC Type: 1 = CD-ROM
wodim: Operation not permitted. Warning: Cannot raise RLIMIT_MEMLOCK limits.
scsidev: '/dev/cdrom'
devname: '/dev/cdrom'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Wodim version: 1.1.10
Using libusal version 'Cdrkit-1.1.10'.
SCSI buffer size: 64512
Device type : Removable CD-ROM
Version : 5
Response Format: 2
Capabilities :
Vendor_info : 'HL-DT-ST'
Identification : 'DVD-RAM GSA-H22N'
Revision : '1.02'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0009 (CD-R)
Profile: 0x0012 (DVD-RAM)
Profile: 0x002B (DVD+R/DL)
Profile: 0x001B (DVD+R)
Profile: 0x001A (DVD+RW)
Profile: 0x0016 (DVD-R/DL layer jump recording)
Profile: 0x0015 (DVD-R/DL sequential recording)
Profile: 0x0014 (DVD-RW sequential recording)
Profile: 0x0013 (DVD-RW restricted overwrite)
Profile: 0x0011 (DVD-R sequential recording)
Profile: 0x0010 (DVD-ROM)
Profile: 0x000A (CD-RW)
Profile: 0x0009 (CD-R) (current)
Profile: 0x0008 (CD-ROM)
Profile: 0x0002 (Removable disk)
Drive current speed: 48
Drive default speed: 48
Drive max speed : 48
Selected speed : 48
Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1114112 = 1088 KB
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
Drive DMA Speed: 99249 kB/s 563x CD 71x DVD
01 00 00 01 00 00 00 00
01 a 01 01 00 00 00 00
Track 1 start -150
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 5
Is not unrestricted
Is not erasable
Disk sub type: Medium Type B, low Beta category (B-) (4)
ATIP start of lead in: -11607 (97:27/18)
ATIP start of lead out: 359849 (79:59/74)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 18
Manufacturer: Plasmon Data systems Ltd.
Speed set to 8468 KB/s
Starting to write CD/DVD at speed 48.0 in real BLANK mode for single session.
Last chance to quit, starting real write in 0 seconds. Operation starts.
Performing OPC...
Blanking entire disk
Errno: 5 (Input/output error), blank unit scsi sendcmd: no error
CDB: A1 00 00 00 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0E 00 00 00 00 64 00 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x64 Qual 0x00 (illegal mode for this track) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.001s timeout 9600s
wodim: Cannot blank disk, aborting.
No entanto, usando o Brasero, eu consigo adicionar arquivos ao CD, mas não consigo apagar o único arquivo .wav contido no mesmo.
Alguém pode me ajudar?
Pelo que entendi eu preciso forçar a quebra das permissões do sistema de arquivos dos CDs.