Estou tentando fazer roda o kismet com placa bcm4312 mas não ta rolando, meu kismet.conf ta com a seguinte linha:
source=bcm43xx,eth1,test
é só essa linha que tem que alterar??
quando rodo o comando sudo kismet retorna o seguinte
Launching kismet_server: //usr/bin/kismet_server
Suid priv-dropping disabled. This may not be secure.
No specific sources given to be enabled, all will be enabled.
Non-RFMon VAPs will be destroyed on multi-vap interfaces (ie, madwifi-ng)
Enabling channel hopping.
Enabling channel splitting.
NOTICE: Disabling channel hopping, no enabled sources are able to change channel.
Source 0 (test): Enabling monitor mode for bcm43xx source interface eth1 channel 6...
FATAL: Failed to set monitor mode: Invalid argument. This usually means your drivers either do not support monitor mode, or use a different mechanism for getting to it. Make sure you have a version of your drivers that support monitor mode, and consult the troubleshooting section of the README.
Done.
se alguém puder ajudar ficarei muito grato.